#TRAINERROAD ANT CHANNEL ERROR ANDROID#
#TRAINERROAD ANT CHANNEL ERROR PRO#

Defaults to a wheel with diameter of 70cm (= 2.199) events speedDataįired when a new wheel speed is calculated cadenceDataįired when a new pedal cadence is calculated StrideSpeedDistance events ssdDataįired when new data been calculated. Here are our recommendations for your indoor cycling setup, including the best indoor bike trainers, equipment, and. SpeedCadence methods setWheelCircumference(circumferenceInMeters)Ĭalibrates the speed sensor. Before you begin training inside, you'll need some specific equipment. HeartRate events hbDataįired when new heartbeat data is received. detach()įired after the sensor is correctly detached. Common to all Scanners methods scan()Īttaches the sensors and starts scanning for data from every devices in range. Common issues are around WiFi sharing the same channel as ANT+ and not using extension leads. The same thing here, always on all rides. detachedįired after the sensor is correctly detached. I'm also experiencing a lot of drops en Edge830, on trainerroad the powermeter, HR, and cadence shows stready, everything to a garmin ant+ antenna. detach()įired after the sensor is correctly attached. Common to all Sensors methods attach(channel, deviceId)Īttaches the sensors, using the specified channel and deviceId (use 0 to connect to the first device found). shutdownįired after the stick is correctly closed. close()įired after the stick is correctly initialized. Returns a cancelation token with a method cancel you can use to stop waiting.Ĭallback is a funcion accepting a single Error parameter and it will be called when the stick is open (with the parameter undefined) or in case of failure (with the parameter set to the error). Tries to open the stick, waiting for it if not available right now. methods is_present()Ĭhecks if the stick is present. The maximum number of channels that this stick supports valid only after startup event fired. Objects GarminStick2 and GarminStick3 properties maxChannels never detach a sensor before receiving the attached or detached event of the previous sensor.

never attach a new sensor before receiving the attached or detached event of the previous sensor.

#TRAINERROAD ANT CHANNEL ERROR ANDROID#

You can use the Android beta via Bluetooth Smart, ANT+ and ANT+ FE-C.

#TRAINERROAD ANT CHANNEL ERROR PRO#

never attach a sensor before receiveing the startup event Please note: TrainerRoad will not be adding support for the ANT PowerBeam Pro as it uses a proprietary ANT communication protocol that differs from ANT+.

Trainerroad ant channel error